LBO is designed to perform in a variety of operating conditions, both on and off road. It normally loads by means of “skidding” load over rear rolling tail pipe carrying diverse workloads and handling the harsh demands of the drill site loading conditions. Strong trailer construction and efficient design works together for the safest most and trusted name on the job.
Quality
Design – Construction – Craftsmanship - On-Time Delivery
Performance
Service Life - Light Tare Weight – Low Deck Height – Fabricated Main Beams & Side Rails – Removable, “greasable” Rolling Tail
Safety
Low Center of Gravity – Warning Decals – Engineered & Tested at Factory – Walking Floor in Gooseneck
Value
Resale Value - Owner/Operator's Cost - Factory Tested - Payload
Customer Support
Dealer support - Technical Support - Product training – Factory Written Warranty
Specifications:
Capacity: 70,000 lbs concentrated in 16’-0”.80,000 lbs distributed in 40’-0”.GAWR & Tire rating determine legal loads
Deck Length(end of gooseneck to end of trailer): 40’ standard
Gooseneck: Arched, narrow, fixed with walking plate in gooseneck. To help drag cable and travel fore and aft.
Front: Pick up eye ,fairing roller with spherical bearings in back of gooseneck
Anchor lug: Lug in front to anchor winch line
Swing Clearance: 96”
Upper Coupler: 52” king pin height, 2” pin, and 22” setting.
Main Deck height: 42” at rated capacity.
Beams: Four beam design, 130,000-psi yield flanges and 80,000 psi yield web. Fabricated 21” deep main beams ,siderail fabricated 18”
Crossmembers: 8” I –Beam 24” centers
Floor: 1 ¾” Apitong with bridge clips and carriage bolts on every other cross member. Center floored
Tie Downs: 10 D rings welded to siderail per side, 4 pin pockets on side (one on tail pipe) on outside of flange, 2” sch 160, 2¾” OD x 1 5/8” ID. Two pair pipe pockets 4¾”OD x 3¾” ID x 12” deep, inside side rail flange located one at first bolster and one approximately 20/22’ ahead
Rear: Rolling tail pipe 8 ½”, large self aligning spherical roller bearings, greasable through end cap, with two sets of greasable overload bearings
Wheel covers: Open wheel cover area
Suspension: Ridewell Model 240 Air Ride, 60” spread, none of the axles are built as lift axles.
Controls: No automatic/manual height control system standard. Manual dump valve standard.
Axles: Two axles, OEM, 5” round with5/8” wall, tapered spindles, 25,000 lb capacity. Standard with U-Bolts
Pit Cock valve: Pit cock valve over air bags
Hubs: 10 stud, hub piloted, long studs, steel hub.
Drums: Cast drum
Seals: Oil
Brakes: 16½” X 7” Air. Parking brakes on one axle.
ABS: 2S-1M
Slack Adjusters: Automatic slack adjusters
Wheels: Steel disc wheels 8.25 X 22.5
Tires: OEM, 255/70R22.5, 16PR (Low Profile) radial tires
Mudflaps: Black anti-spray with Kalyn Siebert logo
Finishing(Paint and trim): Shot blasted prior to paint. Epoxy primer and black polyurethane paint. Air, electrical and hydraulic lines installed after painting is completed
Lights & Electrical: Sealed beam with mid turn signal, 12 volt. 7-way plug. Connections under gooseneck and out front of bumper
Conspicuity Tape: Discontinuous on sides
Manual: One operator manual per order will be provided. Parts manual available as option
Weight: 20,850 lbs + 3% tolerance. For trailers other than standard specification, weight and dimensional drawing will be provided by plant after order is received and accepted.
Warranty: Backed by five-year prorated frame warranty and three –year prorated paint warranty. One-year on remainder.
Options:
Square Gooseneck
Additional deck length
Swing clearance,108”,120”
Two place kingpins(drop in)
Three place kingpin( drop in
Flip gooseneck (length TBD)
Heavier flange material
Lugs ,air and electrical for booster
Wide load sign
9’-0” width
¾” axle wall
Liquid filled gauge
Synthetic grease
Additional tie downs D-rings
Aluminum wheels-polished or mill finished
2 Speed landing gear
D-ring on siderail welded to vertical surface
275/70R 22.5 16PR Tires
295/75R 22.5 16 PR Tries
11R/22.5 16 PR Tires
11R/24.5 16 PR Tires
Gray Wheels (at time of order)
Paint-color-contact RSM
Inverted fifth wheel
Raise and lower valve
Wheel covers
Parking brakes
Spare tire and wheel
Spare tire rack(side of gooseneck)
Tool box in gooseneck
Full width Gooseneck with 1 5/16” apitong(96) swing
Air operated pop up rollers(deck or bolster)
Lift axle
Additional weevil pin sockets
Weevil pins
Hub odometer
Document holder
Single point spring suspension
Tandem axle booster ,14’ spread ,shimable
Tandem axle booster,14’ spread ,fixed
Steel wheel cover,non-load bearing (booster)
Tandem axle jeep
Triple axle jeep
Fairing roller on jeep
Frame width roller on jeep
Three brake light package
Led lights
Additional side marker lights
Plug @rear for beacon 4-way
Plug male 4 way
Internal strobe, Two lights ,toggle switch
○ Customer Service ○ Warranty/Registration ○ Parts & Service
Market analytics
